Shop Light FAQ
7
4-ft 5000-Lumen White LED Linear Shop Light
What is the distance between the base of the lamp to the part that screws into the socket? i need it to fit into a deeply recessed socket. 3-4 inches.
Question
Answer
Its E26 socket is telescoping, and it can extend from 3.25" to 5.25" long, so it can be fit into a deeply recessed socket up to 5.25".
8
4-ft 5000-Lumen White LED Linear Shop Light
Do you need to install a switch to the outlet or can you use a pull chain?
Question
Answer
You need to install a switch to the outlet for operation. A pull chain is not applicable.
9
Motion shop light
Everything has been fine. Motion detection worked .... Until about 2 weeks ago. Nothing has changed as to where it is plugged in and what else is plugged in, etc.. Now it has decided to start flickering. It was too distracting while I was working. Any suggestions on how to rectify this situation?
Question
Answer
1.The possibility is that the switch is losing its ability to control motion. Please try switching to manual mode to see if the light continues to flicker or not.
2.Please check for any loose connections or wires. If the problem persists, it might be helpful to try the light in a different outlet or with a different power source to rule out any potential electrical issues.
10
Solar shop light
Does this have low temp charging protection?
Question
Answer
No, this light doesn't equip with low temp charging protection. Its working temp is -20 degrees C to 40 degrees C for your reference.
11
Solar shop light
I bought a solar LED shop light. For what they recommended for a yard shed, and I've had it. Set up and the sun, even though we don't get the sun constant during the day, but it's off and on and I've it's been set up now for two weeks and it does not light up. I don't know, I followed everything by the instructions. I've read this thing 1/2 a dozen times but it it just doesn't light up. So if someone could call me and maybe tell me what I've done or something I'd certainly appreciate it.
Question
Answer
Please try disconnecting it, normally, the light should come on. It may be due to insufficient power, causing startup issues, or it could be at a critical point.
Then re -plug all cord again to try.